Description
DC3.7-10V FG-100 DDS Function Signal Generator Module 1Hz - 500KHz Frequency Counter Sine Square Triangle Sawtooth Wave
1. Features:
1. Small size, complete functions, simple operation and easy to carry.
2. It can be powered by an adapter or a lithium battery.
3. DDS has good accuracy and frequency stability, suitable for oscilloscope scanning time factor calibration.
4. Square wave output, suitable for oscilloscope attenuator and probe pulse characteristic adjustment.
5. Together with the oscilloscope, it can be used to test and debug electronic circuits, and test and measure the frequency characteristics and impulse response of audio amplifiers.
2. Technical indicators:
1. Frequency range: sine wave 1Hz-500kHz (where the output amplitude is flat to 200 kHz, and the output amplitude will decrease as the frequency increases), other waveforms 1Hz-50kHz (but the upper limit of the adjustable frequency is not limited, if The requirements for distortion and shaking are not high, and the frequency of use can be further increased).
2. Resolution: 1Hz.
3. Output waveform: sine wave, square wave, triangle wave, forward sawtooth wave, reverse sawtooth wave, electrocardiogram, noise wave.
4. Sine wave distortion: <1% below 1kHz, <0.5% above 1kHz.
5. Output amplitude: maximum ±10V (P-P).
6. Output impedance: 50 ohms.
7. DC offset: maximum ±10V, with shutdown function.
8. All setting parameters can be saved
9. There are filters that can be turned on and off, which can adapt to sine and pulse waveform output.
10. Power supply: DC3.7-10V. Recommend to use DC5V adapter, or 3.7V lithium battery.
11. Dimensions: 140x80x27 mm
12. Weight (including accessories): about 0.175 kg
DC3.7-10V FG-100 DDS Function Signal Generator Module 1Hz - 500KHz Frequency Counter Sine Square Triangle Sawtooth Wave 
